This is one of the fastest cutters when used in conjunction with the FH-2000 Oil Filter Holder. This cutter centers around the filter quickly, with no parts to change, and you can cut the filter in either direction. Cuts all Champion® and Tempest® 3.7 diameter filters. Rugged 6061-T6 aluminum construction. Roller bearings provide smooth rolling action. Hardened hardware throughout. No parts to change and it can cut in either direction. There is a clearance hole for filters with a stud. Made in USA. Lifetime Warranty. Filter Not Included. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Easy to use, works great.
FC-2000 OIL FILTER CAN CUTTER
FC-2000 OIL FILTER CAN CUTTER
FC-2000 OIL FILTER CAN CUTTER
Good
FC-2000 OIL FILTER CAN CUTTER
Great product! Worked very well.
FC-2000 OIL FILTER CAN CUTTER
Quality made in USA. I recommend this tool to anyone.
FC-2000 OIL FILTER CAN CUTTER
It worker ok, it would be better if it was square then you could put it in a vice.
FC-2000 OIL FILTER CAN CUTTER
Works great
FC-2000 OIL FILTER CAN CUTTER
I only used this cutter once since purchase and it works perfectly. I already knew this from working with tubing and pipe cutters, you don’t crank down on the knob to apply a lot of pressure initially on the cutter wheel. Just turn the knob a little bit and then spin the tool around the filter can and then turn the knob a little more after each spin around the can. Just let the cutter wheel do the work slowly.
This product works great. Sharp blade cuts filters open quickly. I put the filter into my bench vise, rotate the tool, the filter is open.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, this will work with all of the Champion filters.